S1 Binary outputs The display of the eight binary feedbacks (freely programm- able) provides information about communication with the control unit, thus providing support in commissioning. Depending on the configuration, a set output 1 (active high) or 0 (active low) is shown. |
S2 Binary inputs Display of five binary inputs (freely parameterizable), whereby the control unit represents incoming movement commands with 1 instead of 0. |
S3 Analog values Display of the analog 0/4–20-mA inputs and of the analog feed- backs from and to the control unit. |
S4 Absolute values Display of the absolute and relative values for positions and torques. |
S5 Firmware Display of firmware (software version), including date. |
S6 Serial number Display of the serial number of electronics, actuator and control unit. |
S7 Counter readings PowerOn cycles: How often has the actuator been turned on and off? Operating hours: Actuator under live voltage Motor run time: Motor in motion. |
Warning alerts
The display of warning alerts provides valuable information on the operating status of an actuator. This can allow a complete failure to be detected early on and averted. |
Failure/malfunction
Should an actuator fail, the white backlight of the display will automatically change to red, which can be seen already from a great distance. |
Signal lamps
Colored LEDs are used to clearly show operating statuses. Two programmable LEDs for visualizing movement and reaching of a respective end position, 2 LEDs for visualizing standby status, 1 LED for visualizing a respective active communication interface (Bluetooth or infrared). |